Get Adobe Flash player
Newsletter
Highlights

20 TON BUCKETS IN STOCK NOW
The following 20 - 27 TON Buckets are IN STOCK NOW
Read more...

Contact Info
an image
Bucketmouth Pty Ltd
Factory 7/100 Bald Hill Road
PAKENHAM
3810
Pakenham

Email: bucketmouth@bigpond.com

0419097055
+61 +419 097 055

    The_Eccentic_Boss_Header.png   

 This unique boss lets you change the Pin Centre, Pin Size & Width Between the Ears on an Excavator Bucket or Attachment.

Multi_Fit_Boss_3.png       mULTI_fIT_bOSS_7.png       Multi_Fit_Boss_Diagram_.jpg

 

How_it_Works.png 

Two eccentric bosses replace the standard bosses currently in the front of the ears on your buckets.

Standard bosses are still used in the back of the ears on your bucket.

                    Bucket_Ears_Assembly.png                 

Change_Pin_Centre_Red_Header.png 

1. Remove front pin from bucket.

2. The boss consists an eccentric male & female bush. Remove the male (pull out) and rotate the eccentric hole to the pin centres you require.

     Multi_fit_Boss_Male_Spline.png       Multi_Fit_Boss_Female_Spline.png          boss_spline.png

 

Changes_Width_Between_Bosses.png

1. Move spacers from one side of the boss to the other side of the boss.

                      Boss_Spacer.png

   Changes_Pin_Size_Red_Header.png

1. Insert sleeve into the eccentric hole. Sleeves available from 65mm - 90mm.

          Multi_Fit_Sleeve.png                       Multi_Fit_Sleeve.png

Re insert the pin into the bucket & your bucket is ready to be used by the entire range of Excavators.

 

 

         Machines_Bucket_Fits_Info_Banner.jpg